Oil stays in engines longer and works harder than ever before, which creates damaging sludge. Don’t put clean oil into a dirty engine. Use Nulon Engine Oil Flush to remove damaging sludge deposits and extend the life of your engine. Recommended and safe for use in all engine types: petrol, diesel, LPG, old or new.
Add 1 bottle for up to 6 litres of engine oil before oil change. Start engine and let idle for 10-15 minutes. Stop engine and completely drain whilst old oil is still warm. Change oil filter and refill with a quality engine oil.
NOTE: To keep your engine clean, use Engine Oil Flush prior to each oil change. Nulon
Engine Oil Flush is safe to use with all engine parts and seals.
SAFETY DIRECTIONS: Avoid contact with eyes or skin. DO NOT SWALLOW. Keep out of reach of children. Combustible. Keep away from heat or flame. Do not breathe vapour. Wash hands thoroughly after use. Not to be used as a food container.
FIRST AID: For advice, contact a Poisons Information Centre (Phone e.g. Australia 131 126; New Zealand 0800 764 766) or a doctor (at once). If swallowed, do NOT induce vomiting. If in eyes, hold eyelids apart and wash the eye continuously with running water. If skin contact occurs, flush with running water.
Average rating of5.0/5
2 customer reviews
Engine Oil Flush or Pro-Strength Extreme Oil Flushshould be added to your engine oil just prior to changing your engine oil and directions of use on the rear of the bottle must be followed. The vehicle must not be driven when Engine Oil Flush is in the engine.
Nulon ani-wear Engine Treatments based on PTFE can be added to engine oil at any time but are best added to new engine oil after an oil change. Please follow directions of use for the Nulon Engine Treatment products to ensure your engine receivesthe best possible protection from wear and friction.
No, oil changes should still occur at the intervals set by the vehicle manufacturer.
No, all engine treatment products should only be used as per dosage recommendations as per directions. We would also recommend to not use more than one additive in an engine at one time.
No, all Nulon engine treatments are compatable with synthetic and mineral oils
It is recommended to only use one Nulon engine product at each oil change.
Running a very thick oil can sometimes cause issues in modern engines. An area that is often overlooked when oil comsumption is a problem is hardened valve stem seals. Oil will bypass hardened seals and allow oil into the combustion chamber via the valve stems. Consumption as high as one litre per thousand kms can be caused by valve stem seal leakage. Nulon Engine Stop Leak can rejuvenate hardened valve stem seals and should be used before moving to a thicker engine oil.
It will dilute the engine oil, effecting its viscosity and ability to protect vital components. We recommend replacing engine oil and filter before driving.
Worn Engine Repair,Modern Engine Treatment and Passenger Car Diesel Engine Treatment are recommended at each oil change. For extra protection use Pro-Strength Extreme Performance Engine Treatment (petrol) and Pro-Strength Heavy Duty Diesel Engine Treatment (diesel)
Yes, Nulon engine treatments (Worn Engine Repair,Modern Engine Treatment ,Pro-Strength Extreme Performance Engine Treatment,Passenger Car Diesel Engine Treatment, Pro-Strength Heavy Duty Diesel Engine Treatment etc) will reduce cylinder blowby and reduce crankcase pressures. Engine Stop Leak will also rejuvinate hardened oil seals
This depends to the fuel type (petrol or diesel) and also the age and mileage on the vehicle. Worn Engine Repair for high mileage engines with some wear, Modern Engine Treatment for engines in good condition, Pro-Strength Extreme Performance Engine Treatment as a long term treatment. Small capacity diesel engines should use Passenger Car Diesel Engine Treatment, while for larger diesel engines use Pro-Strength Heavy Duty Diesel Engine Treatment.